
Simulation of nuclear reactor tubes under postulated accidental conditions
Nuclear power is an important energy source. It could be the perfect replacement for coal-based fuels due to its low rate of exhaustion. It is considered a renewable energy resource due to this detail. As attractive as it sounds, countries around the globe have their own reservations against its usage due to the threats they pose in case of an accident or a natural calamity. The exposure of radioactive material to the atmosphere can have lethal effects, as seen from the Fukushima and Chernobyl disasters.
At Bhabha Atomic Research Center, I simulated the behavior of fuel-clad nuclear reactor tubes under postulated accidental conditions. The simulation helped me derive the burst-time of the fuel tubes. The burst-time was a crucial parameter for designing the Emergency-Core-Cooling-System (ECCS). The ECCS was responsible for sending additional coolant to the reactor core under a loss-of-coolant accidental condition.
This project helped me learn a lot about nuclear reactor safety and helped me pick up essential skills like CAD modeling, finite element analysis, and technical writing. More importantly, it helped me take a big step towards ensuring the safe operation of a nuclear reactor.
Modelling the reactor tubes
-
A 3D model of the entire experimental setup was made in Autodesk Inventor.
-
The key features of the model were Inlet, Outlet, Fluid Domain, and Fuel-clad tube.
-
The model of the fuel-clad nuclear reactor tubes was virtually divided into 60 segments (6 radially & 10 longitudinally) for ease of analysis.

Simulation of Test Equipment
-
A 3 step analysis was conducted to derive the burst-time of the reactor tubes.
-
The 3 step analysis included:
-
Velocity Profile Analysis: To compute the heat transfer coefficient (h) on the tube surface based on the wall velocity of the surrounding fluid.
-
Temperature Analysis: The temperature at the center of each segment of the fuel-tube was found out.
-
Structural Analysis: Derivation of burst parameter with respect to temperature was done.
-


Verification & Validation of Simulation
-
A material constitutive model was created for the creep burst parameter.
-
The experimental data showed that the tube burst at 100s for an internal pressure of 7.7 bar. The simulation predicted a burst at 97s.
-
The experimental data and simulation results were very close and the error can be justified by the minor assumptions considered during the simulation.
